Single Laminate Worktop Jointing Fabrication Service


In stock
Lead Time: 14 Days
98% of 100

Maximum 4 characters

Maximum 4 characters

Available on all laminate worktops *Excluding Zenith Compact laminate 

Our experienced fabrication specialists do the precision routing for you, leaving you safe in the knowledge that the joint will fit perfectly first time!

Worktops are delivered carefully packaged and ready for DIY installation.

Savoy Timber have been supplying and fabricating worktops for over 20 years.

This Fabrication Service includes: 

    Component Quantity
    Worktop butt & scribe connector bolts 3

To submit your measurements please see the single joint diagram within the picture section of the listing.

  • Select the side you would like your joint
  • Measure wall to wall and enter A measurement in mm into the A field 
  • Measure wall to wall and enter B measurement in mm into the B field

NB - This product is to scribe/mitre two worktops to produce an  'L' shape worksurface. 

Please Note:. Measurements are wall to wall - ignore any current joints

We do not send off cuts should you require your off cuts there is a small additional postage charge, you must inform us of any requirement for off cuts when ordering. 

To see how to correctly measure for this service click here.

This product is for a single joint, such as required to join two worktops in a L shape.

Please note: On receipt of you order we will contact you to confirm joint direction and worktop measurements. We will not proceed with fabrication until we have written confirmation. This service is only available for kitchen worktops purchased from Savoy Timber. 

Please see below

More Information
Lead Time 14 Days
Write Your Own Review
You're reviewing:Single Laminate Worktop Jointing Fabrication Service
Your Rating
We found other products you might like!